LiftMaster GT electric garage door opener
LiftMaster logo

GT

LiftMaster logo

GT

LiftMaster GT electric garage door opener

Features

The GT model is a heavy industrial-duty trolley door opener, as manufactured by The Chamberlain Group and is for use on standard lift sectional doors. It is rated for 25 cycles per hour constant high loading. In excess of 90 cycles/day.

Radio Receiver
  • Trolley type door opener
  • Voltage/phase:
    • Single-Phase: 115 V and 230 V
    • 3-Phase: 208 V, 230 V and 460 V, 575 V
  • Horsepower: available in ½, ¾ and 1 HP
  • Additional headroom required: 4 in (102 mm)
  • Required depth: Door height + 48 in
  • Built‑in 3‑channel, 315 MHz radio receiver accepts up to 23 Security+® or unlimited DIP switch remotes. 3‑button remotes can be programmed for OPEN/CLOSE/STOP operation
  • Maintenance Alert SystemTM establishes a routine maintenance schedule based on the number of cycles or calendar date. Includes self‑diagnostic system that allows you to troubleshoot up to eight different error codes
  • Timer‑to‑close allows programming in 1‑sec or 15‑sec increments and permits timed automatic door closure after the door reaches the fully open position; requires monitored photosensors, either CPS‑U, CPS‑UN4, or a 4‑wire edge, using the CPS‑EI edge interface
  • Continuous‑duty high‑starting torque motor with instant reverse.
  • Thermal motor overload can be easily reset from the 3‑button floor level control station
  • Removable hinged electrical box cover.
  • Quiet‑gliding rail spacers.
  • Single‑or three‑phase, capacitor start on single‑phase.
  • Motor is removable without affecting limit switch settings.
  • All operators are factory preset to C2 wiring, providing momentary contact to open and stop, with constant contact to close. Monitored entrapment protection, using approved photo sensors CPS‑U are standard. All other wiring types, B2, T, TS and FSTS, can be selected with the selection of a switch. LiftMaster CPS‑UN4 and CPS‑RPEN4 photosensors or a monitored 4‑wire sensing edge (via a CPS‑EI Edge Interface Card) are optional. Logic 4.0 door openers can only accept UL‑approved LiftMaster CPS‑U, CPS‑UN4, CPS‑RPEN4 or CPS‑EI monitored entrapment protection devices.
  • 10:1 first stage using heavy‑duty gears running in oil bath; cast iron housing; #41 chain second stage; #41 chain on trolley.
  • Sealed roller bearing in gear reducer.
  • Heavy‑duty solenoid‑actuated brake.
  • Adjustable friction clutch helps protect against major damage to door and operator should the door meet an obstruction.
  • Spring‑loaded disconnect for emergency manual operation.
  • Motor overload protection.
  • High‑strength dual L‑rail track with exclusive nylon quiet‑gliding chain guides on rail spacers for quiet, smooth operation.
  • High‑strength dual L‑rail track with nylon quiet‑gliding chain guides on rail spacers for quiet, smooth operation.
  • 1.5 second delay‑on‑reverse circuit to prevent premature door and operator wear.
  • The Timer‑to‑Close automatically closes the door - programmable in 1‑second or 15‑second increments.
  • The mid‑stop stops the door at programmable mid‑stop during open travel.
  • The Maximum Run Timer signals the door to reverse or stop if closing time exceeds maximum by more than 10 seconds.
  • Maintenance alert system (5 000 to 10 000 cycles).
  • UL and CSA listed.
  • 2‑year warranty.

Standard security systems

Your security, our priority!

CPS® commercial protector system®

The presence of primary entrapment protection is standard CPS‑U for all modes. Primary entrapment protection devices are monitored continuously to ensure safe operation of the door and limit door opener functionality should an obstruction be detected or in the event of device failure. Optional LiftMaster Monitored Entrapment Protection devices, CPS‑UN4, CPS‑RPEN4 and CPS‑EI, are designed to work in conjunction with LiftMaster commercial door openers to provide enhanced door safety and a broad range of modes and features to end users. Either monitored photo-sensor or monitored 4‑wire sensing edge (in conjunction with the CPS‑EI Edge Interface) protection may be selected, but one must be detected by the LiftMaster logic 4.0 or medium-duty logic circuit board in order to unlock full functionality.

Security+ 2.0 logo

Warning

Garage doors and garage door openers can be dangerous if not installed and verified by a professional and not used properly. Children must be supervised by an adult when they are inside or in proximity of the garage.

CPS®commercial protector system®

Security+ 2.0 logo

The presence of primary entrapment protection is standard CPS-U for all modes. Primary entrapment protection devices are monitored continuously to ensure safe operation of the door and limit door opener functionality should an obstruction be detected or in the event of device failure. Optional LiftMaster Monitored Entrapment Protection devices, CPS-UN4, CPS-RPEN4 and CPS-EI, are designed to work in conjunction with LiftMaster commercial door openers to provide enhanced door safety and a broad range of modes and features to end users. Either monitored photo-sensor or monitored 4-wire sensing edge (in conjunction with the CPS-EI Edge Interface) protection may be selected, but one must be detected by the LiftMaster logic 4.0 or medium-duty logic circuit board in order to unlock full functionality.


Warning

Garage doors and garage door openers can be dangerous if not installed and verified by a professional and not used properly. Children must be supervised by an adult when they are inside or in proximity of the garage.

Included in package

GT.jpg
LiftMaster GT door opener
  • 3‑button control station with LED
  • Radio receiver & external radio control terminal
  • Chain pack (according to door height)
  • Installation hardware
  • Rail according to door height

Copyright Garaga Inc. | Privacy Policy and Conditions of Use | Sitemap